How to turn Up or Down your Prestige "Z" or APSRS Series Remote Start Run Time:
Tech Note: You have 5 seconds to perform each step, not all the steps within 5 seconds but each step to the next.
Step 1: Turn the vehicle's ignition ON with a key (do not start the vehicle): Press & release the button on the system's antenna 3X slowly: The system will respond by flashing the dash lights and/or beeping the horn 1X depending on the model of system: After this is seen/heard:
Step 2: Turn the ignition OFF then ON again: The system will respond with 1 long pulse and 2 short pulses and/or 2 flashes: After this is seen/heard:
Step 3: Turn the ignition OFF then ON again: The system will respond with 1 long pulse and 3 short pulses and/or 3 flashes: After this is seen/heard:
Step 4: Next (leaving the ignition ON) Press & release the button on the system's antenna 3X slowly: The system will respond by flashing the LED built into the system's antenna in a 3 flash/pause/3 flash pattern indicating you are now in the "remote start run-time adjustment mode":
Step 5: Now, press & release the LOCK button on the remote (or the 1 button on 1 button remotes) until the system responds with the number of flashes/beeps corresponding with the desired setting below:
1 BEEP/FLASH: 5 MINUTES
2 BEEPS/FLASH: 10 MINUTES
3 BEEPS/FLASH: 15 MINUTES
4 BEEPS/FLASH: 20 MINUTES
5 BEEPS/FLASH: 45 MINUTES
6 BEEPS/FLASH: 60 MINUTES
Step 6: Once your at your desired setting, turn the ignition OFF. Wait, within a few seconds, the system will sound/flash. DONE.