Reported Issue: Remote starter system worked fine until vehicle was serviced. Keyless entry works fine but when the remote starter is activated it will only turn the ignition ON, no crank
Situation: Pre-Equipped/Installed
Specific Vehicle, System or Bypass Interface: 2012 Ford F150 w/Code Alarm System & Flashlogic FLTB1
Possible Cause: Flashlogic FLTB1 lost programming
Possible Fix: Reset & reprogram module to vehicle (2 keys to vehicle required for programming): Unplug both plugs from Flashlogic module: Press & hold in the small black push button on the Flashlogic module, while still holding the button in, plug just the black 4-pin plug in, wait, the LED on the Flashlogic module will begin the flash rapidly, when this is seen release the button. Plug in the remaining harness. The LED will be slowly flashing green, while this is seen press & hold in the button again until the LED turns on solid green then turns off, after this is seen release the button. The Flashlogic module is now reset and ready to be reprogrammed to the vehicle:
Module Programming: MUST have 2 OEM keys to the vehicle to program (cannot use a cloned key): Turn ignition ON with the first key (DO NOT start the vehicle): The LED on the Flashlogic module will turn on solid RED then turn OFF: Within 5 seconds turn ignition OFF remove key and turn ignition ON with 2nd key, LED will again turn ON Solid RED then turn OFF, within 5 seconds remove key and press & release the button on the Flashlogic module: within another 5 seconds activate the remote starter: wait, the LED will turn Solid RED to GREEN: Module reprogrammed to vehicle: press and release the vehicle's brake pedal and test remote start.